IC Realtime IPEG-B40F-IRW2 Quick Start Guide - Page 4
IC Realtime IPEG-B40F-IRW2 Manual
View all IC Realtime IPEG-B40F-IRW2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
. Step 5: Tighten down the mounting screws. See Figure 2-5. Waterproof connector installation for network port (if applicable): For a device with a plastic enclosure, you can directly rotate the dome enclosure clockwise, cover the dome enclosure and complete installation. See figure 2-9. Figure 2-5 Adjusting Sunshield and Angle: ● Use the supplied wrench to loosen set screw and adjust shade. Tighten down Screw when finished. See Figure 2-7. ● To Adjust Angle, loosed the set screw and rotate the camera. Be careful not to rotate the camera too much as it can compromise the cabling. See Figure 2-8. Figure 2-7 4 | www.icrealtime.com Figure 2-8 Figure 2-9 Step 1: Keep the convex groove outward and install the rubber ring into the network port, keep the smaller hole of the rubber ring outward and install the fixing rubber ring into the main body of the waterproof connector. Step 2: Pull the network cable without crystal head through main body of waterproof connector, fixing rubber ring and waterproof locking cover, make the crystal head of network cable, and then insert it into the network cable Step 3: Put the main body of waterproof connector on the network port and rotate it clockwise to lock the network port and waterproof connector firmly Step 4: Put the waterproof locking cover on the main body of waterproof connector and rotate it clockwise to lock the waterproof connector and waterproof locking cover firmly. It is recommended to wrap the assembly with electrical tape for an extra protective measure.