IC Realtime IPEG-B40F-IRW2 Quick Start Guide - Page 5

2B. RESTORE FACTORY DEFAULTS/ INSTALL SD CARD Important: Make sure the device is powered when attempting to press RESET button. Step 1 Use the supplied hex wrench to unscrew the access panel below the camera. Skip to Step 3 if only installing SD card. Step 2 Slightly press the RESET button for 15-30 seconds to complete the reset function. See Figure 2-10. The camera will reboot when the reset process is complete. 3A. OVERVIEW The IP Config tool is used to search the local network for IC Realtime devices as well as modify the IP addresses and upgrading firmware. This software can be downloaded at: https://icrealtime.com/downloads under Desktop Utility Apps 3B. OPERATION Double click the "ConfigTools.exe" icon to run. The interface will be displayed as shown in Figure 3-1. Click on the blue circle icon with the two arrows to refresh and scan the network. Figure 2-10 Step 3 (If installing SD Card) Adjust the Micro SD Card to a proper direction shown in Figure 2-10. Step 5 Close the access panel, tighten down locking screw and reinstall camera. 5 | www.icrealtime.com Figure 3-1