IC Realtime MAIP-D2360-S Product Manual - Page 18

3 Installation Important  Before you complete the installation and setup, do not remove the electrostatic attraction film on the transparent enclosure. Otherwise it may result in injury.  After remove electrostatic attraction film, do not touch dome enclosure in case it may leave stain.  Before the installation, please make sure the installation surface can sustain at least 3X weight of the bracket and the camera. 3.1 General Installation Please refer to Figure 3- 1 for device installation information. You can see there are installation screws in the accessories bag for you to install the device conveniently. Figure 3- 1 3.2 Device Installation Steps Step 1 Use the inner hex wrench from the accessories bag to unfasten the 3 hex screws on the dome camera enclosure and then remove it. Step 2 Take the installation position diagram from the accessories bag and then paste it on the installation ceiling or the wall according to the monitor area. Please dig three bottom holes of the plastic expansion bolts according to the diagram. Take three expansion bolts from the accessories bag and then insert them to the holes you just dug and then fix firmly. If 13