Icom A220 Instruction Manual - Page 9
Rear panel
View all Icom A220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PANEL DESCRIPTION 1 r FREQUENCY EXCHANGE (FLIP-FLOP) SWITCH [e] ■■Rear panel 01 ➥ Push to exchange the standby frequency with the ac- tive frequency. (p. 5) ➥ Hold down for two seconds to enter the direct frequen- w cy setting mode. (p. 6) t MEMORY SWITCH [MEM] q e q Hold down for two seconds to enter a displayed frequency into any blank regular memory channel or delete or revive the selected memory channel (depending on the operating mode). y RECALL SWITCH [RCL] ➥ Push to enter ➥ Hold down for and two esexictothnedsmtoemenotreyrmthoedSe.e(tpti.n8eg)s menu. (p. 18) ➥ Push to exit the Settings menu. (p. 18) u LIGHT-SENSITIVE DETECTOR This detector senses ambient light. The detector is used to automatically adjust "DISP LOW" or "DISP HIGH" (pp. 23, 24) when the "DISP MODE" (p. 23) is set to 'AUTO.' For regular type q ANTENNA CONNECTOR Conqnect the antenna connectorw. w D-SUB 25 PIN CONNECTOR Connect a 13.8 V or 27.5 V DC power supply, speaker, headset and third party GPS receiver*. Refer to 'INSTALLATION GUIDE' for details. *Ask your dealer for available GPS receiver details. Optional MBA-3 i INNER (Small) TUNING DIAL [DIAL] ➥ Rotate to set the standby frequencies (kHz digit) (p. 5), memory channels (p. 8), and menu mode settings. (pp. 18, 19) ➥ Hold down for two seconds to turn ON the dial/panel lock mode. (p. 15) o OUTER (Large) TUNING DIAL [O-DIAL] Rotate to set the standby frequency (MHz digit) (p. 5), group memory channel (p. 8), select the input digit for group name (p. 10), and so on. 2