Icom F3201DEX / F4201DEX Operating Instructions - Page 21
Setting the beep level
View all Icom F3201DEX / F4201DEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3 BASIC OPERATION Setting the beep level You can adjust the beep level between 1 and 5, or 1 (linked) and 5 (linked). When a linked option is selected, you can adjust the beep level by rotating [VOL]. qqRotate [VOL] to turn OFF the transceiver power. wwSet [ROTARY SELECTOR] to any channel other than Channel 16. eeWhile holding down [Lower], rotate [VOL] to turn ON the power and enter the beep level adjustment mode. rrPush [Upper] to change the beep level as shown to the right. • A beep sounds every time you push [Upper]. Therefore, you can determine the current level setting by the increasing loudness of the beep that sounds. • To determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] repeatedly, listening for the loudest beep (level 5). Pushing [Upper] once after the loudest beep will select 1 (Linked). Repeatedly push [Upper] to select the desired linked level. ttRotate [VOL] to turn OFF the power to exit the beep level adjustment mode. NOTE: This operation may not be available, depending on the presetting. [Upper] [Lower] [ROTARY SELECTOR] [VOL] Pushing [Upper] 5 4 3 2 1 5 (Linked) 4 (Linked) 3 (Linked) 2 (Linked) 1 (Linked) 3-8