Icom F3201DEX / F4201DEX Operating Instructions - Page 26
Emergency Call, ◇ Lone Worker Emergency Call
View all Icom F3201DEX / F4201DEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
3 BASIC OPERATION Emergency Call When [Emergency] is held down for the specified time period*, the emergency signal is transmitted once, or repeatedly, on the specified emergency channel. * Depending on the presetting. A repeat emergency signal is automatically transmitted until you turn OFF the power. Depending on the preprogrammed settings, receiving a matching 5-tone code cancels the transmission. When no emergency channel is specified, the signal is transmitted on the previously selected channel. If you want to cancel the emergency call, hold down [Emergency] again before transmitting the call. If your transceiver is programmed for Silent operation, you can transmit an Emergency call without the beep sounding and the status indicator lighting. IMPORTANT: We recommend you set an emergency channel individually to provide for reliable emergency call operation. NOTES Depending on the presetting, the following functions are automatically activated. • Auto TX function After the emergency call transmission, audio from the microphone is automatically transmitted for a specified time period.* • Auto RX function After the emergency call transmission, the transceiver stands by in the Audible mode for the specified time period.* * Depending on the presetting. DDLone Worker Emergency Call When the Lone Worker function is turned ON, and no operation is performed for the specified time period*, the transceiver enters the emergency mode, and then the countdown for the emergency call transmission starts. After the specified time period* has passed, an emergency call is automatically transmitted once, or repeatedly*. If someone operates the transceiver before the call is transmitted, the transceiver exits the emergency mode, and the emergency call is cancelled. * Depending on the presetting. qqHold down [Lone Worker] for 1 second to turn ON the Lone Worker function. wwPush [Lone Worker] to turn OFF the Lone Worker function. DDMan Down Emergency Call When the transceiver has been left in a horizontal position for the preprogrammed time period, the transceiver enters the emergency mode, and then the countdown for the emergency call transmission starts. After the preprogrammed time period, an emergency call is automatically transmitted once, or repeatedly, depending on the pre-programmed settings. If the transceiver is placed in a vertical position before the first transmission, the transceiver exits the emergency mode and the emergency call is cancelled. 3-13