Icom IC-A6 Instruction Manual - Page 34

Troubleshooting - problem

Get Icom IC-A6 PDF manuals and user guides View all Icom IC-A6 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

9 TROUBLESHOOTING If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center. PROBLEM POSSIBLE CAUSE SOLUTION REF. No power comes on. • The battery is exhausted. • Bad connection for the battery pack. • Recharge the battery pack. pgs. 7, • Check the connection to the transceiver. 25-27 No sound comes from • Squelch level is too deep. the speaker. • Volume level is too low. • Set squelch to the threshold point. • Set [VOL] to a suitable level. pgs. 8, 9 Transmitting impossible. • Some channels are receive only. • The battery is exhausted. • Change channels. • Recharge the battery pack. p. 8 p. 25-27 The display channel can not be selected. • Lock function is activated. • Push , then push [7• ]. p. 11 Scan does not start. • All memory channels are not programmed • Set the "TAG" settings of desired programmed as "TAG" channels. channels. p. 17 No beep sounds. • Beep tones turned OFF. • Push , then push [8•BEEP] to adjust p. 11 the beep tone level 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
29
9
TROUBLESHOOTING
If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
No power comes on.
•
The battery is exhausted.
•
Recharge the battery pack.
pgs. 7,
•
Bad connection for the battery pack.
•
Check the connection to the transceiver.
25
–
27
No sound comes from
•
Squelch level is too deep.
•
Set squelch to the threshold point.
pgs. 8, 9
the speaker.
•
Volume level is too low.
•
Set [VOL] to a suitable level.
Transmitting impossible.
•
Some channels are receive only.
•
Change channels.
p. 8
•
The battery is exhausted.
•
Recharge the battery pack.
p. 25
–
27
The display channel
•
Lock function is activated.
•
Push
, then push [7
•
].
p. 11
can not be selected.
Scan does not start.
•
All memory channels are not programmed
•
Set the
“
TAG
”
settings of desired
p. 17
programmed as
“
TAG
”
channels.
channels.
No beep sounds.
•
Beep tones turned OFF.
•
Push
, then push [8
•
BEEP
] to adjust
p. 11
the beep tone level