Icom IC-F1000 Operating Guide - Page 21

BASIC OPERATION 2 ■ Setting the Ringer level 1 These instructions are for the non-display type transceivers. The Ringer level can be adjusted between 1 and 5, or 1 NOTE: 2 This operation may not be selectable, depending on the 3 (Linked) and 5 (Linked). When a Linked option is selected, the ringer audio level is adjustable by rotating [VOL]. presetting. Ask your dealer for details. 4 5 qqRotate [VOL] to turn OFF the transceiver power. wwSet [ROTARY SELECTOR] to Channel 16. 6 eeWhile holding down [Lower], rotate [VOL] to turn ON the power and enter the Ringer level adjustment mode. rrPush [Upper] to increase, or push [Lower] to decrease the Ringer level. • Repeatedly pushing [Upper] first selects 1 (lowest) to 5 (highest), and then selects the lowest linked level, 1 (Linked) to 7 [ROTARY SELECTOR] Pushing Pushing [Upper] [Lower] 8 [VOL] 9 5 10 the highest, 5 (Linked). Repeatedly pushing [Upper] or [Lower] repeats the cycle. See the illustration on the right. • The adjustable range is 1 to 5 or 1 (Linked) to 5 (Linked). • A beep sounds after pushing [Upper]. Therefore, you can determine the current level setting by the increasing loudness of the beep that sounds. • To determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] up to 10 times, listening for the loudest beep (level 5). Pushing [Upper] once after the loudest beep will select 1 (Linked). Repeatedly push [Upper] or [Lower] to select the desired linked level. ttRotate [VOL] to turn OFF the power to exit the Ringer [Upper] [Lower] 4 11 3 12 2 13 1 14 5 (Linked) 15 4 (Linked) 16 3 (Linked) level adjustment mode. 2 (Linked) 1 (Linked) 18