Icom IC-F4230D Instruction Manual - Page 13

3 BASIC OPERATION ■■Turning power ON Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. (p. 12) qqRotate [VOL] to turn ON the power. wwIf the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. • The 10-keypad may be used for password input, depending on the transceiver's version: • The keys in the table below can be used for password input. • The transceiver detects numbers in the same block as identical. Therefore "01234" and "56789" are the same. [VOL] [Side3] [P0]/[P1]/ [P2]/[P3] KEY Side3 01 23 4 NUMBER 56 78 9 eeWhen the "PASSWORD" indication does not clear after inputting 4 digits, the input code number may be incorrect. Turn the power off and start over in this case. DDBattery type selection The battery type must be selected according to the attached battery type when turning ON the transceiver. Ask your dealer for details. qqTurn OFF the power. wwWhile pushing and holding [Emer] and [PTT], turn ON the power by rotating [VOL] to toggle the attached battery type. • After the display appears, release [Emer] and [PTT]. • "DRY BATT" is displayed for about 3 seconds then "L" appears when the battery case use is selected. In this case, the transmit output power is low. • "LI-ION" is displayed for about 3 seconds when the Lithium-ion battery use is selected. [VOL] Appears [Emer] [PTT] Dry battery mode 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 8