Icom IC-M85 Instruction Manual - Page 26

9 SET MODE ■■ Set mode items (Continued) DDSQL Key Action " " The function temporarily opens the squelch. • Pu (Push): The Monitor function is activated by holding down [SQL] for more than 1 second. The squelch opens while holding down the key. • Ho (Hold): The Monitor function is activated by holding down [SQL] for more than 1 second. The squelch stays open until the user pushes any key. DDBacklight " " Turns the Automatic Backlight function ON or OFF. ••OFF: The function is OFF. ••ON: The backlight turns ON for 5 seconds when the user pushes any key except [PTT]. DDContrast " " Selects the transceiver's display contrast. ••Hi: The transceiver's display contrast is set to High. ••Lo: The transceiver's display contrast is set to Low. DDPower Save " " Turns the Power Save function ON or OFF. ••OFF: The function is OFF. ••ON: The Power Save function reduces current drain by deactivating the receiver circuit of the transceiver at specific intervals. 21 DDCH Display Selects the number of digits to display the channel number. You can select settings for each channel group. ••3d: The channel number is displayed in 3 digits. (Example: 78A) ••4d: The channel number is displayed in 4 digits. (Example: 1078) DDScrambler Code " " Set the voice scrambler code to between 1 and 32. DDVOX Level " " Sets the VOX gain level to between 1 (The lowest sensitivity) to 10 (The highest sensitivity). Higher values make the VOX function more sensitive to your voice. DDVOX Delay " " Sets the VOX Delay to between 1 (The shortest) to 6 (The longest) in 0.5 second steps.* *Example: If the VOX delay is set to 2, transmitter stays ON for 1 second. The VOX Delay is the amount of time the transmitter stays ON after you stop speaking before the VOX switches to receive.