Icom IC-M85UL Instruction Manual - Page 30

Using the HM-184UL

Get Icom IC-M85UL PDF manuals and user guides View all Icom IC-M85UL manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

10 SPECIFICATIONS AND OPTIONS ■■Using the HM-184UL Microphone [PTT] Belt clip To attach: Attach the connector of the speaker microphone to the multi connector on the transceiver and tighten the screw. Turn OFF Speaker Turn OFF the transceiver before attaching or detaching the microphone NOTE: ••NEVER immerse the connector in water. If the connector becomes wet, BE SURE to dry it before attaching to the transceiver. ••The microphone element is located at the top left of the speaker microphone, as shown in the illustration above. To maximize the readability of your transmitted audio, hold the microphone approximately 5 to 10 cm (2 to 4 inches) from your mouth, and then speak at your normal voice level. 25 Screw Coin CAUTION: Firmly attach to the multi connector, but do not overtighten. A loose connection will allow water intrusion into the connector. Over-tightening the connection can damage the transceiver.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
25
10
SPECIFICATIONS AND OPTIONS
■
Using the HM-184UL
NOTE:
•
NEVER
immerse the connector in water. If the connector
becomes wet,
BE SURE
to dry it before attaching to the
transceiver.
• The microphone element is located at the top left of the
speaker microphone, as shown in the illustration above.
To maximize the readability of your transmitted audio,
hold the microphone approximately 5 to 10 cm (2 to 4
inches) from your mouth, and then speak at your normal
voice level.
Turn OFF the transceiver before
attaching or detaching the microphone
[PTT]
Speaker
Microphone
Belt clip
To attach:
Attach the connector of the speaker microphone to
the multi connector on the transceiver and tighten the
screw.
Screw
Coin
CAUTION:
Firmly attach to
the multi connector, but do not
overtighten. A loose connection
will allow water intrusion into
the connector. Over-tightening
the connection can damage the
transceiver.
Turn OFF