Icom IC-SAT100 Basic Manualeng/ger/esp/fra/ita - Page 14

6 INFORMATION ■■ About CE and DOC Hereby, Icom Inc. declares that the versions of ICSAT100 which have the "CE" symbol on the product, comply with the essential requirements of the Radio Equipment Directive, 2014/53/EU, and the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive, 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.icomjapan.com/support/ ■■ Disposal The crossed-out wheeledbin symbol on your product, literature, or packaging reminds you that in the European Union, all electrical and electronic products, batteries, and accumulators (rechargeable batteries) must be taken to designated collection locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them according to the laws in your area. ■■ Technical Information ••Output Power: 7 W ••SAR 10g: 4.46 W/kg ■■ Certification Refer to the "Certification" screen for certifications acquired with the transceiver. ([OK] > Information > Certification) Certification ■■ FCC information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, Including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ••Reorient or relocate the receiving antenna. ••Increase the separation between the equipment and receiver. ••Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ••Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Changes or modifications to this transceiver, not expressly approved by Icom Inc., could void your authority to operate this transceiver under FCC regulations. BASIC MANUAL 13