Icom IC-SAT100 Basic Manualeng/ger/esp/fra/ita - Page 3

ENGLISH ■■ Precautions R DANGER! NEVER use or charge Icom BE CAREFUL! The transceiver meets battery packs with non-Icom transceivers IP67* requirements for dust tight and 1 or non-Icom chargers. Only Icom battery waterproof protection. However, once packs are tested and approved for use with the transceiver has been dropped, dust 2 Icom transceivers or charged with Icom and waterproof protections cannot be chargers. Using third-party or counterfeit guaranteed due to the fact that the 3 battery packs or chargers may cause transceiver may be cracked, or the smoke, fire, or cause the battery to burst. waterproof seal damaged, and so on. * Only when the jack cover or the optional R WARNING! NEVER hold the speaker microphone is attached. transceiver so that the antenna is very close to, or touching exposed parts of the NEVER place the transceiver in an body, especially the face or eyes, while insecure place to avoid inadvertent use by transmitting. unauthorized persons. R WARNING! NEVER operate the transceiver with a headset or other audio accessories at high volume levels. The continuous high volume operation may cause a ringing in your ears. If you In some countries, using a satellite communication device may be prohibited, or a license is required. Make sure you comply with all applicable laws and regulations in your area. experience the ringing, reduce the volume level or discontinue use. About E-marking: Detailed installation notes for Icom mobile transceivers to be CAUTION: DO NOT short the terminals of the battery pack. Shorting may occur if the fitted into vehicles are available. Please contact your Icom dealer or distributor. terminals touch metal objects such as a key, so be careful when placing the battery Icom, Icom Inc. and Icom logo are registered packs (or the transceiver) in bags, and so trademarks of Icom Incorporated on. Carry them so that shorting cannot occur with metal objects. Shorting may damage not only the battery pack, but also (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries. the transceiver. The Bluetooth® word mark and logos are registered CAUTION: DO NOT use harsh solvents such as Benzine or alcohol when cleaning. This could damage the equipment surfaces. If the surface becomes dusty or dirty, wipe it clean with a soft, dry cloth. trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Icom Inc. is under license. Other trademarks and trade names are those of their respective owners. 3M, PELTOR, and WS are trademarks of 3M Company. All other products or brands are registered CAUTION: DO NOT place or leave trademarks or trademarks of their respective holders. the transceiver in excessively dusty environments. This could damage the transceiver. Iridium, and the Iridium logo are registered trademarks of Iridium Satellite LLC and its affiliates. DO NOT place or leave the transceiver in direct sunlight or in areas outside of the specified temperature range: -30°C (-22˚F) ~ +60°C (+140˚F) BASIC MANUAL 2