Image Fitness 12.5 Elliptical English Manual - Page 5

2. Have another person hold the Upright (2) in the position shown. Connect the Upper Wire Harness (30) to the Lower Wire Harness (42). Insert the connectors on the Wire Harnesses up into the Upright (2). Carefully pull the upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses. Insert the Upright (2) into the Frame (1). Be careful to avoid pinching the Wire Harnesses (30, 42). Attach the Upright with two M10 x 108mm Button Screws (70), two M10 Split Washers (73), and two 7.6mm Spacers (47). Make sure that the curved sides of the Spacers are facing the Upright. Be careful to avoid damaging the Wire Harnesses with the Button Screws. Do not tighten the Button Screws yet. 3. Slide a Weld Spacer (28) onto the axle on the left side of the Upright (2), with the open side of the Weld Spacer facing the Upright. Apply a small amount of the included grease to the axle. Slide an Upper Body Arm (29) onto the axle on the left side of the Upright (2). Using the included Push Nut Tool (96), tap a Push Nut (31) onto the axle; make sure that the Push Nut is turned as shown in the inset drawing. Attach the other Upper Body Arm (29) to the right side of the Upright (2) in the same way. 2 Pull 2 70 73 47 73 47 Do not pinch the wire harnesses during this step. 30 42 1 3 2 29 Grease 28 31 29 96 Axle 31 Axle 4. Look inside one of the Handlebar Cover Sets (26) and 4 locate the square tabs connecting the two halves. Gently lift the tabs and disconnect the halves. Hold the two halves of the Handlebar Cover Set (26) around the tube on the left side of the Upright (2). Align the halves and press them together until they lock. Attach the other Handlebar Cover Set (26) to the right side of the Upright (2) in the same way. 2 See the inset drawing. Attach the Water Bottle Holder (13) to the Upright (2) with two M4 x 16mm Screws (94). 26 5 13 94 2 26