Image Fitness 3.8 English Manual - Page 11
Lubricate an M10 x 115mm Bolt 55. Slide an M10
![]() |
View all Image Fitness 3.8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
15. Press a 50mm Square Outer Cap (17) onto each end 15 of the Small Stabilizer (25). Attach the Small Stabilizer (25) to the Bench Frame (5) with two M10 x 65mm Carriage Bolts (40) and two 17 11 5 M10 Nylon Locknuts (11). Note: There is an indenta- tion around the holes on one side of the Small Stabilizer. This side must be facing the floor. 25 40 17 16. Press a 50mm x 70mm Outer Cap (10) onto each end of the Large Stabilizer (26). 16 Turn the Large Stabilizer (26) so the warning decal is in the position shown. Attach the Large Stabilizer to the Bench Frame (5) with two M10 x 65mm Carriage Bolts (40) and two M10 Nylon Locknuts (11). Note: There is an indentation around the holes on one side of the Large Stabilizer. This side must be facing the floor. 5 10 26 11 Decal 10 17. Press two 20mm x 40mm Inner Caps (28) into each Backrest Tube (27). Press four 20mm x 40mm Inner Caps into the Backrest Adjustment Bracket (36). Lubricate an M10 x 180mm Bolt (22). Attach the Backrest Tubes (27) to the welded tube on the Backrest Adjustment Bracket (36) with the Bolt, two M10 Washers (6), and an M10 Nylon Locknut (11). Make sure that the Backrest Tubes are turned as shown. The indicated holes are not centered in the Backrest Tubes but are closer to one side. Turn the Backrest Tubes so the holes are closer to the floor. Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily. 18. Attach the Backrest Adjustment Bracket (36) to the bracket on the Bench Frame (5) in the following way: 17 Lubricate 27 22 6 Holes 28 28 Welded Tube 36 40 28 6 11 28 Lubricate an M10 x 115mm Bolt (55). Slide an M10 18 Washer (6) onto the Bolt and insert the Bolt through the indicated tube of the Backrest Adjustment Bracket Lubricate (36). 55 Hold the Backrest Adjustment Bracket (36) over the bracket on the Bench Frame (5). Insert the Bolt through one side of the bracket. Slide the 15mm x 10.2mm x 60mm Spacer (57) onto the Bolt. Next, 6 insert the Bolt through the other side of the bracket and the other tube of the Backrest Adjustment Bracket. Secure the Bolt with an M10 Washer (6) and an M10 Nylon Locknut (11). Do not overtighten the 5 Nylon Locknut. 11 27 36 6 57 11 Bracket
![](/manual_guide/products/image-fitness-38-english-manual-5d0f623/11.png)