Insignia NS-55E560A11 User Manual (English) - Page 18
Understanding the basics, Turning your TV on or off, Selecting the video input source, Selecting - won t turn on
View all Insignia NS-55E560A11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
NS-55E560A11 Insignia 55" LED-LCD TV, 1080p 5 Press or to highlight Antenna or Cable, then press ENTER. Your TV automatically starts scanning for channels available in your viewing area. Note You can press EXIT to stop the auto channel search, but you will need to run the auto channel search again to create a channel list. Understanding the basics Note Unless otherwise noted, all tasks in this section are based on using the remote control. Turning your TV on or off To turn your TV on or off: 1 Make sure that the power cord is connected to a power outlet. 2 Press POWER to turn on your TV. The power indicator LED blinks red, then turns off. 3 Press POWER again to turn off your TV. Your TV enters Standby mode and the power indicator LED turns red. Warning When your TV is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord. Note If your TV does not receive an input signal for several minutes, it automatically goes into standby mode. Selecting the video input source To select the video input source: 1 Turn on your TV, then press INPUT. The Source List opens. Source list TV AV Component VGA HDMI 1 HDMI 2 HDMI 3 HDMI 4 2 Press or to highlight a video input source, then press ENTER. Selecting a channel To select a channel: • Press CH + or CH - to go to the next or previous channel on the memorized channel list. • Press the number buttons to enter the channel number you want, then wait for the channel to change or press ENTER to immediately change the channel. • To select a digital sub-channel, press the number buttons to select the main digital channel, press (dot), then press the number button for the sub-channel. Wait for the channel to change, or press ENTER to immediately change the channel. For example, to tune to channel 5.1, press 5, (dot), then 1. • Press RECALL to go to the previous channel. Adjusting the volume To adjust the volume: • Press VOL + or VOL - to increase or decrease the volume. • Press MUTE to turn off the sound. Press MUTE again to turn the sound back on. Viewing channel information To view channel information: • Press INFO to view an information banner. The information banner shows the current program information such as channel number, video input source, and resolution. • Digital channel information-Displays the channel number, station name, channel label, broadcast program name, TV rating, signal type, audio information, resolution, CC mode, current time, and current program start and end times. • Analog channel information-Displays channel number, channel label (if preset), signal type, audio information, and resolution. Using the electronic program guide (EPG) To use the electronic program guide (EPG): 1 When watching digital programs, select the channel you want to watch. 2 Press GUIDE. The EPG opens and shows detailed information about the current program. The amount and type of information depends on the information provided by the broadcaster. 3 Press or to display information about future programs on the selected channel. 4 Press GUIDE one or more times to close the EPG. You can also wait 30 seconds for the EPG to close automatically. 14 www.insigniaproducts.com