Insignia NS-HTVMF0C User Manual - Page 11
Option 2: Installing on a solid concrete or concrete
View all Insignia NS-HTVMF0C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
FIXED-POSITION WALL MOUNT FOR TVs 40-70 in. STEP 5 - Option 2: Installing on a solid concrete or concrete block wall (requires Concrete Installation Kit CMK1) CAUTION:To prevent property damage or personal injury, never drill into the mortar between the blocks. Mount the wall plate directly onto the concrete surface. 1 Align the center of the wall plate template (R) at the height (a + b - 1.5 in.) you determined in the previous step, make sure that it is level, then tape it to the wall. 2 Drill two pilot holes through the template to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit, then remove the template. 3 Insert the concrete wall anchors (C3) into the pilot holes and use a hammer to make sure the anchors are flush with the concrete surface. 4 Align the wall plate (10) with the anchors, insert the lag bolts (C1) through the lag bolt washers (C2), then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate. CAUTION: • Use only the upper slotted holes to mount the wall plate. Do not use the lower slotted holes. • DO NOT over-tighten the lag bolts (12). . Align the center of the template with the height mark (a+b) you made in step 4. 3 in. (75 mm) * Minimum solid concrete thickness: 8 in. (203mm) * Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm). * Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm). You'll need C3 C1 C2 Wall plate (10) Level Wall plate template (R) 3/8 in. masonry drill bit Drill 1/2 in. socket C2 (2) wrench C1 (2) C3 (2) Hammer Tape www.insigniaproducts.com 11