Insignia NS-HTVMM1703-C User Guide - Page 10
STEP 5 - Option 1: Installing on a wood stud* wall
View all Insignia NS-HTVMM1703-C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
NS-HTVMM1703-C STEP 5 - Option 1: Installing on a wood stud* wall Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm). 1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder. 2 Align the center of the wall plate template at the height (a + b) you determined in the previous step, make sure that the template is level, then tape it to the wall. 3 Drill four pilot holes through the template to a depth of 2 in. (50 mm) using a 3/16 in. (5 mm) diameter drill bit, then remove the template. 4 Make sure that the wall-mount arm on the wall-mount is perpendicular to the wall plate, align the wall plate with the pilot holes, insert the lag bolts (B1) through the lag bolt washers (B3), then through the holes in the wall plate. Make sure that the wall plate is level, then tighten the lag bolts with the box wrench only until they are firm against the wall plate. CAUTION: Use only the four center holes to mount the wall plate. Do not use the slotted side holes. • DO NOT over-tighten the lag bolts (B3). * Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm). * Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm). Stud B3 B1 Box wrench Magnetic removable bubble level Align the center of the template with the height mark (a+b) you made in step 4. Stud finder 2 in. (50 mm) 3/16 (5 mm) You'll need Box wrench B1 (4) Wall mount B3 (4) Magnetic removable bubble level 3/16 in. wood drill bit Edge-to edge Drill Wall plate template stud finder Tape 10 www.insigniaproducts.com