Insignia NS-PMM6230 User Guide - Page 12

Install the tube cap, Tighten the arm knob to secure the arm.

Get Insignia NS-PMM6230 PDF manuals and user guides View all Insignia NS-PMM6230 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

4 Slide the other monitor plate and support arm assembly (1 or 4) onto the support tube, making sure that the curved portions of the arm are pointed up. 5 Make sure that the wider opening on one of the arm support rings (5) is facing up, then place the ring on the support tube at the level you want the mounting plate and support arm. Use a Phillips screwdriver to tighten the pre-installed screw in the ring to hold the ring in place. 6 Tighten the arm knob to secure the arm. 7 Install the tube cap (6) on top of the support tube using the M4 x 10 mm screw (C), then tighten the screw with the 3 × 3 mm Allen wrench (D). 12 www.insigniaproducts.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
www.insigniaproducts.com
12
4
Slide the other monitor plate and support arm assembly (
1
or
4
) onto the support tube, making sure that the curved
portions of the arm are pointed up.
5
Make sure that the wider opening on one of the arm support rings (
5
) is facing up, then place the ring on the support
tube at the level you want the mounting plate and support arm. Use a Phillips screwdriver to tighten the pre-installed
screw in the ring to hold the ring in place.
6
Tighten the arm knob to secure the arm.
7
Install the tube cap (
6
) on top of the support tube using the M4 x 10 mm screw (
C
), then tighten the screw with the
3 × 3 mm Allen wrench (
D
).