Insignia NS-SBAR User Manual (English) - Page 12

NS-SBAR Soundbar Home Theater System To turn off the second room signal: 1 On the soundbar, press both the Wireless Next Source button and the Volume Down button for five or more seconds. 2 The Audyssey Dynamic Volume Red indicator LED will briefly flash on/off twice, to show that the second room signal is now off. To turn on the second room signal: 1 On the soundbar, press both the Wireless Next Source button and the Volume Down button for five or more seconds. 2 The Audyssey Dynamic Volume Red indicator LED will briefly turn on to show that the second room signal is now on. Care and maintenance Use the following guidelines to maintain the appearance of your soundbar: • Use a soft, dry cloth to clean the soundbar. • Avoid using harsh detergents or cleaning fluids. • Do not vacuum any of the soundbar components, because permanent damage could result. Troubleshooting Check the following information for the possible cause and solution for a problem before contacting the nearest service center or dealer for repairs. Symptom The soundbar does not turn on No sound No communication between the soundbar and your Rocketboost device The remote control doesn't work The sound from the left and right channels is reversed Solution • Securely connect the power supply cable from the AC power supply to the soundbar and the AC power cable from the AC power supply to an AC power outlet. • Make sure that all connections are correct. • Press the Volume + button. • Press the INPUT button to choose the right sound source. • If you are using Rocketboost input, press the Next Source button to select another sound source. • Make sure that the Hub Status switch on the sender/receiver is set correctly. • Make sure that the power indicators on the sender/receiver and the soundbar turn solid blue/green. If the power indicators blink slowly, it means there is no active link between the devices. Unplug the AC power cables, then plug them back in and try to establish the link again. (See "To establish communications with other Rocketboost devices:" on page 7.) • Replace the batteries • Operate the remote more closely to the soundbar. • Check the left and right channel connections and connect them correctly. Specifications Length Depth Height Total power Power per channel Speakers 38 in (965 mm) 4.6 in (117 mm) without wall mount bracket 5.5 in (139.7 mm) with wall mount bracket 3.4 in (86 mm) without mounting feet 4.3 in (109.2 mm) with mounting feet 120 W (< 3% THD+N) 30 W for L and R channels 60 W for subwoofer 2 x 0.75" tweeters 2 x 2.0" midranges 2 x 3.5" woofers Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. www.insigniaproducts.com 9