Intel BLKD201GLYL Product Specification - Page 24
Audio Subsystem
![]() |
View all Intel BLKD201GLYL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Intel Desktop Board D201GLY Technical Product Specification 1.7.2 Parallel Port The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup program to set the parallel port mode. For information about The location of the parallel port connector Refer to Figure 6, page 37 1.7.3 Keyboard and Mouse Interface PS/2 keyboard and mouse connectors are located on the back panel. NOTE The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is connected or disconnected. For information about The location of the keyboard and mouse connectors Refer to Figure 6, page 37 1.8 Audio Subsystem The audio subsystem consists of the following devices: • SiS964L Southbridge • ADI AD1888 audio codec The audio subsystem includes these features: • Signal-to-noise ratio ≥ 90 dB • Supports wake events (driver dependent) • Mic in pre-amp that supports dynamic, condenser, and electret microphones The audio subsystem supports the following audio interfaces: • Front panel audio header, including pins for: ⎯ Line out ⎯ Mic in • Back panel audio connectors: ⎯ Line in ⎯ Line out ⎯ Mic in 1.8.1 Audio Subsystem Software Audio software and drivers are available from Intel's World Wide Web site. For information about Obtaining audio software and drivers Refer to Section 1.1.4, page 14 24
![](/manual_guide/products/intel-boxd201glyl-product-specification-3bbb24c/24.png)