Intel D845EPI Intel Desktop Board D845EPI Product Guide English - Page 28
Installing and Removing Memory, Installing DIMMs
View all Intel D845EPI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Intel Desktop Board D845EPI Product Guide Installing and Removing Memory CAUTION To be fully compliant with all applicable Intel SDRAM memory specification addendums, the board requires DIMMs that support the Serial Presence Detect (SPD) data structure. You can access the PC Serial Presence Detect Specification at: http://www.intel.com/technology/memory/pcsdram/spec/ ✏ NOTE Remove the card in the AGP connector before installing or upgrading memory to avoid interference with the memory retention mechanism. The desktop board has two DIMM sockets arranged as DIMM 0 and DIMM 1, as shown in Figure 7. If installing a single DIMM, install it in DIMM 0. Refer to the Main Memory heading on page 14 for memory requirements. Installing DIMMs To install DIMMs, follow these steps: 1. Observe the precautions in "Before You Begin" on page 21. 2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect the AC power cord. 3. Remove the computer's cover and locate the DIMM sockets (see Figure 7). Figure 7. Installing Memory 0 1 OM16291 28