Intel IXM5414E User Guide - Page 169

The IXM5414E switch module supports user-based security that you can use to prevent unauthorized users from accessing the switch module or changing its settings. This section tells you how to log on to the switch module for the first time. Complete the following steps to connect to the switch module through the Telnet interface: 1. Display a window that contains a DOS prompt command line; for example, C:\>. 2. Type the following command on the DOS prompt command line and press Enter: telnet x.x.x.x where x.x.x.x is the IP address for your switch module When you first connect to the switch module, you will be prompted to enter a user ID followed by a password. Enter USERID in response to the prompt for a user ID and enter PASSW0RD in response to the prompt for a password (notice the use of the zero and not the "O"). This will give you Read/write access to the switch module. By default, the switch module has one Read-only account named "GUEST." The password for the Read-only GUEST account is left blank, just press Enter. For security you should change these default passwords after you log onto the system for the first time. / NOTE All user IDs and passwords are CASE SENSITIVE. Only a user with Read/write privileges can add new user accounts or make changes to existing user accounts. Another function available with a Read/write account is updating firmware and configuration files. Changing configuration settings The IXM5414E switch module has two levels of memory: normal random-access memory (RAM) and non-volatile RAM (NVRAM). When you enter a configuration change, the new settings will be immediately applied to the switching software in RAM. The new settings will remain in effect until the switch is restarted or you make another change. To make the changes permanent you need to issue the save config command which stores the current configuration in NVRAM. When the switch configuration settings have been saved to NVRAM, they become the default settings for the switch. These settings will be used every time the switch module is restarted. / NOTE Some settings require you to restart the switch before they will take effect. Make sure you save the new configuration to NVRAM first. There are two ways to change the configuration stored in NVRAM: • Save a new configuration using the save config command. • Reset all configuration values to the initial settings listed in Appendix Appendix C "Run-time Switching Software Default Settings" on page 231 by issuing the clear config command. This restores the configuration settings that were entered at the factory and causes a reboot. Loading the factory default configuration will erase any user accounts (and all other configuration settings) that you might have entered and return the switch module to its original state at the time of purchase. Intel® Blade Server Ethernet Switch Module IXM5414E 159