Intel SC5650 Technical Product Specification - Page 128
External Memory Device
View all Intel SC5650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Peripheral and Hard Drive Support Intel® Server Chassis SC5650 TPS VSC410* Pin Name P2_4 P2_5 I/O Type O O Power Well 3.3V 3.3V P2_6 O 3.3V P2_7 O 3.3V P3_0 I/O 3.3V P3_1 I/O 3.3V. P3_2 I/O 3.3V P3_3 I/O 3.3V Programming Description Test Point System Function Reset State TP_LED_DRV9_FLT_N Test Point TP_FM_DRV9_PRSNT _N Test Point TP_LED_DRV10_FLT_ N Test Point TP_FM_DRV10_PRSN T_N Clock signal of SGPIO interface SGPIO_CLK Load signal of SGPIO interface SGPIO_LOAD SDATAIN signal of SGPIO SGPIO_DATAOUT0 interface SDATAOUT signal of SGPIO interface SGPIO_DATAOUT1 Initial Value Connection 4.3.5 External Memory Device The 6HDD passive SAS/SATA HSBP contains a non-volatile 8Mbit Serial SPI FLASH Memory for Boot and Run-Time/Configuration code storage. The device resides on the SPI interface of the VSC410* controller. The Serial SPI Flash memory operates from the 3.3V rail. 4.3.6 LEDs The 6HDD passive SAS/SATA HSBPs contain a green STATUS LED and an amber FAULT LED for each of the hard disk drives. The STATUS LED is driven by the SAS/SATA hard disk drive itself. The FAULT LED is driven by the VSC410* controller whenever a condition, as defined by the firmware, is detected. Table 124. LED Function Status LED Green Amber on Condition On Blink (0.5s on 0.5s off, 50% duty cycle of a 1s) Blink (1s on 1s off, 50% duty cycle of a 2s) On Blink Definition HDD Active Spin up/spin down(SAS HDD) Formating(SAS HDD) HDD Fail Rebuild Note: For SAS drives, the green LED will be on when the drive is installed and ready. For SATA drives, the green LED will be off when the drive is installed and ready. 114 Revision 1.2 Intel order number E39531-004