Intel SR2625UR Service Guide - Page 42

Hard Disk Drive Carriers The server system ships with five drive carriers for installing five SAS or Serial ATA (SATA) hot-swap drives. Note: SAS drives are only supported on the Intel® Server System SR2600URLX (active version). The top leftmost drive bay can be converted to be used as a floppy bay. To use the bay for a floppy drive, the AXXUSBFLOPPY accessory kit must be used. For instructions on installing hard drives, see "Installing and Removing a Hot-swap Hard Drive (Intel® Server System SR2600UR only)" on page 71. Note: Drives can consume up to 17 watts of power each. Drives must be specified to run at a maximum ambient temperature of 45°C. Note: The Intel® Server System SR2600UR does not support all SAS or Serial ATA (SATA) hard drives. For a web link to a list of supported hard drives, see "Additional Information and Software" on page 4. Slimline Optical Drive Carrier The slimline optical drive carrier can be used with a single slimline optical drive or USB floppy drive. One slimline carrier is included with your server system; the optical drive must be purchased separately. You cannot install both an optical drive and a USB floppy drive. The drive in the optical drive carrier is NOT hot-swappable. The system power must be turned off to insert or remove the slimline optical drive carrier. For instructions on installing an optical drive or USB floppy, see "Installing or Removing a Slimline Optical Drive or Internal USB Floppy (Intel® Server System SR2600UR only)" on page 77. To use one of the drives provided by Intel, use the following order codes: • Slimline DVD-ROM Drive: AXXSATADVDROM • Slimline DVD-RW Drive: AXXSATADVDRWROM Note: The Intel® Server System SR2600UR does not support all slimline optical drives. For a web link to a list of supported slimline optical drives, see "Additional Information and Software" on page 4. Intel provides accessory kits for these drives. Flex Bay The server system also provides a multi-purpose drive bay that can support either a tape drive, sixth 3.5-inch hard drive or two fixed 2.5-inch hard drives. This bay is located next to the control panel. To order the optional tape drive kit, sixth hard drive kit, or fixed 2.5inch hard drive kit, use the following order codes: • SATA/SCSI Tape Drive Mounting Kit: ASR2500SATAPE or ADRTAPEKIT • Sixth SAS/SATA Hard Disk Drive (HDD) Kit: ASR2500SIXDRV 22 Intel® Server System SR2600UR/SR2625UR Service Guide