Intermec PM4i EasyADC for Microsoft Great Plains Installation Guide - Page 14
Configuring the CK30s
![]() |
View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
STEP 5 Configuring the CK30s If the CK30s did not turn on when you installed batteries, press I to turn them on. When the CK30s turn on, the Setup Assistant screen appears. Follow the next procedure to configure the CK30s. Keys you need to press are shown in the illustration below. Up arrow Tab Enter Orange key Tab 789 4 F1 5 6 F3 1 F2 2 3 F4 Alt . 0 Esc ABCDE FGH I J K LMNO PQRS T U V I/O W Y Down arrow Enter Green key Esc I/O key Press Enter. The ION Client screen appears. Press U to choose Yes, and then press Enter. Progress messages appear. When this process is finished, the Setup - Complete screen appears. 26 Press Enter. After the CK30 reboots, the blue light starts blinking as the CK30 tries to establish contact with the WA22. This will take a few minutes. When contact is established, the EasyADC login screen appears and the blue light stays solid. Press B and then C. Press 1 for Configuration Utility. Press 3 for Device Settings. Press 1 to set the date: a. Press Enter. b. Use Tab to switch fields and U and D to set the date. c. Press Enter and then Esc to return to the Device Settings screen. Press 2 to set the time: a. Press Enter. b. Use Tab to switch fields and U and D to set the time. c. Press Enter and then Esc to return to the Device Settings screen. Press Esc until you exit the Configuration Utility. When prompted to have your settings persist through a cold boot, press Enter. The System main menu appears. Press Esc. The EasyADC login screen appears. You are now ready to login. 27
![](/manual_guide/products/intermec-pm4i-easyadc-microsoft-great-plains-installation-guide-655bd39/14.png)