Invacare V20RLR Owners Manual - Page 39
Adjusting the Anti-Tippers.
View all Invacare V20RLR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Anti-Tipper Wheels 12 ANTI-TIPPERS/WHEEL LOCKS Anti-Rattle Anti-Tipper Release Buttons Rear Frame Tubing FIGURE 1 Installing Anti-Tipper Adjusting the Anti-Tippers. A 11/2 to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times. 1. Place the wheelchair on a flat surface. 2. Press the release buttons on the wheeled portion of the anti-tipper and slide it up or down to the desired adjustment hole. 3. Check to make sure that the release buttons are fully engaged in adjustment holes. 4. Ensure both anti-tippers are adjusted to the same height. 5. Measure the distance between the bottom of the anti-tipper wheels and the ground/floor. 6. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 11/2 to 2 inches, repeat STEPS 2-5 until the distance is 11/2 to 2 inches. Release Buttons 7. If the 11/2 to 2 inch distance cannot be achieved with the anti-tippers, a different model may be required. Contact an Invacare dealer or qualified technician. 11/2 to 2 inch Clearance FIGURE 2 Adjusting the Anti-Tippers. Part No. 1148116 39 Invacare® Veranda™Wheelchair