Invacare V20RLR Owners Manual - Page 7

Overview

Get Invacare V20RLR PDF manuals and user guides View all Invacare V20RLR manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

2 Overview 2.1 Label Locations IMPORTANT NOTICE The wheel locks on this wheelchair have been pre-set at the factory to comply with the Veterans Administration functional Standard 8320.01 of the Federal Register, paragraph 3.2.4.5.3. If these wheel locks do not meet your needs, follow instructions below. ! CAUTION Any wheel lock adjustments should embed wheel lock shoe at least 1/8" into tire when locked (3/16" on pneumatic tires). INSTRUCTIONS FOR WHEEL LOCK ADJUSTMENTS 1. Loosen wheel lock mounting fastener, which runs through mounting bracket and frame. 2. Slide clamp toward rear wheel until wheel lock shoe is embedded into tire material at least 1/8" when handle is engaged to the lock position (3/16" for pneumatic tires). 3. Tighten mounting fastener to secure mounting bracket in desired location and recheck lock shoe embedding. 4. Inspect for correct locking action BEFORE actual use. 00078X021-0394 Part No. 1148116 2 OVERVIEW Serial Number Label Location is on crossbraces Crossmember Lower Frame Tube 7 Invacare® Veranda™Wheelchair

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
2
OVERVIEW
Part No. 1148116
7
Invacare® Veranda™Wheelchair
2 Overview
2.1
Label Locations
IMPORTANT NOTICE
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
!
CAUTION
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1.
Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2.
Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3.
Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4.
Inspect for correct locking action BEFORE
actual use.
00078X021-0394
Serial Number Label
Location is on crossbraces
Crossmember
Lower
Frame
Tube