Invacare XLTPRO Owners Manual - Page 64

SECTION 9-OPTIONS Installing Hand Crank Handles NOTE: For this procedure, refer to FIGURE 9.9. Horizontal Handles/Delrin Handles 1. Secure handle to hand crank with the screw (Detail "A"). 2. Remove the screw to remove handle from handcrank. DETAIL "A" - HORIZONTAL HANDLES/DELRIN HANDLES Hand Crank Horizontal Handle Screw Vertical Handles 1. Position handle onto crank (Detail "B"). 2. Tighten set screw to secure handle to crank. 3. Reverse STEPS 1‐2 to remove handle. DETAIL "B" - VERTICAL HANDLES Hand Crank Set Screw Tri-pin Quad Handles 1. Remove/install tri‐pin quad handles. Refer to Vertical Handles on page 64 2. Loosen socket screws to adjust handle position (Detail "C"). 3. Tighten socket screws to secure handles in desired position. Vertical Handle DETAIL "C" - TRI-PIN HANDLES V or S Crank Handles Replacement/installation of V or S crank handles should be done by a qualified technician. Socket Screw Tri-Pin Quad Handle FIGURE 9.9 Installing Hand Crank Handles Installing V/S Crankarm Handles For Models Made Before 7/12/07 ƽ WARNING Failure to install handle assembly properly could result in injury. It is recommended to inspect this assembly prior to and after each use. NOTE: For this procedure, refer to FIGURE 9.10 on page 65. 1. Secure the handle to the crankarm housing using the bolt, spacer, and two bearings. Recumbent Handcycle Series 64 Part No 1114850