JVC BM-H1900SU BM-H1900SU monitor instruction manual (243KB) - Page 10

ON-SCREEN MENU CONTROLS By calling up the menu display on screen, various functions can be selected and set as needed. NOTE Calling up the menu display, selecting an item 1. Press the MENU button to call up the menu display on screen (see 1 below). (Press again to make the display disappear.) 2. Press the v or w button to select an item to be set. " " is indicated for the selected item. 3. Press the or button to change the setting. 4. After selecting another item by pressing the v or w button, repeat step 3. These settings are all kept in memory after power is turned off. 5. Press the MENU button to complete. The menu display disappears. q When the menu display 1 (shown at left below) is on screen, press the ENTER button. The display changes to 2 (shown below center). In this state, you can also select the item or change the setting. q When the display 2 is on screen, each time the w button is pressed while the ENTER button pressed, the indication moves up or down on screen (the display 3). Press the MENU button with display 2 or 3 on screen, and the display is restored to 1. q If no operation occurs for about 5 minutes after calling up the menu display on screen, the display disappears automatically. qMENU r ASPECT RAT I O :4-3 F I LTER SELECT :COMB PEAK I NG FREQ. :2.6MHZ PEAK I NG LEVEL:0dB AFC :NORMAL COLOR TEMP. :6500 NTSC SETUP :7.5 COMPO. LEVEL :BETA75 qMEMORY MODE r RGB / COMPO(SDI) :RGB ENTER : 1 AFC :NORMAL 2 AFC :NORMAL 3 ASPECT RATIO (picture aspect ratio switching) The aspect ratio of the picture can be switched between 4:3 and 16:9. When switching to "16-9" on screen, the height of the picture is slightly reduced (see right). q 4:3 4-3 16-9 Setting Function Standard picture aspect ratio (4:3) Displays the picture in 16:9 aspect ratio q 16:9 FILTER SELECT (built-in filter selection) When a composite video signal of the NTSC system (excluding NTSC 4.43) is input to the monitor, either or both of two filters in the monitor can be activated. Setting COMB (comb filter) BOTH (both filters) NOTCH (Trap filter) Function Reduces colour noise in NTSC video signals for clearer pictures. Both comb and trap filters function at the same time. Eliminates dot interference that would show up in the vertical boundary between two different colours. NOTE q The function can be operated and the indication appears only when a composite video signal of the NTSC system (excluding NTSC 4.43) is input to the monitor. 10