JVC BM-H1900SU BM-H1900SU monitor instruction manual (243KB) - Page 12

MEMORY MODE A set of picture settings can be programmed in memory for quick recall when necessary. Recall/release of memory mode Press the MEMORY MODE switch to recall a set of picture settings programmed in memory. Pressing the switch locks the functions of the front-panel PHASE, CHROMA, BRIGHT, CONTRAST controls, and remote-control picture adjustments not to be operated. Press again to release memory mode. NOTE q If you attempt to operate a locked function, "MEMORY MODE ON!!" appears on screen for approx. 2 seconds to indicate the function cannot be operated. Setting programming of the picture being monitored The settings of the picture being monitored can be programmed in memory. Settings programmable in memory mode: q Settings of the CONTRAST, BRIGHT, CHROMA and PHASE controls on the front panel q On-screen menu function settings (except RGB/COMPO(SDI)) q Remote-control picture adjustment settings 1. Check the MEMORY MODE switch is off. 2. Press the MENU button. 3. Press the v or w button to select MEMORY MODE. Then press the ENTER button. 4. q Press the ENTER button to program. q Press the or button to cancel. NOTE q Programmed picture settings are kept in memory after the power is turned off. qMEMORY MODE r Are you sure ? gYes htheENnTER gNo h then or Revision of memory mode Programmed picture settings can be revised if necessary. 1. Press the MEMORY MODE switch to activate memory mode. 2. Press the MENU button to call up display 1 on screen. 12 NOTE q No matter what video signal is input, all items appear on screen. However, depending on the type of input video signal, some functions might not operate even if their settings are made. qMEMORY MODE REV I SE P I C TURE AD JUSTMENT ASPECT RAT I O :4-3 F I L TER SE LEC T :COMB PEAK I NG FREQ. :2.6MHZ PEAK I NG LEVEL :0dB AFC :NORMAL COLOR TEMP. :6500 NTSC SETUP :7.5 COMPO. L E VE L :BETA75 ENTER : 1