JVC DLA-NZ8 Operation Manual - Page 83

Maintenance, Maintaining the Cabinet and Remote Control, Cleaning and Replacing the Filter

Get JVC DLA-NZ8 PDF manuals and user guides View all JVC DLA-NZ8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 83 highlights

Maintaining the Cabinet and Remote Control 0 Gently wipe off dirt on the cabinet with a soft cloth. 0 If it is extremely dirty, wet a cloth in water, wring dry and use it to wipe off the dirt, followed by wiping again with a dry cloth. 0 Pay attention to the following as the cabinet may deteriorate in condition or the paint may come off. 0 Do not wipe with thinner or benzine 0 Do not allow prolonged contact with rubber or plastic products 0 Do not spray volatile chemicals such as insecticide Cleaning and Replacing the Filter Clean the filter every 2000 hours (more often in dusty conditions). Using a filter without cleaning may reduce the brightness of the image. Dirt that enters the unit may also appear as shadows on the image. 234 1 Sponge filter (gray) 1 Loosen the screws at the four corners and remove the cover 0 The screws cannot be removed from the cover. Do not try to remove the screws from the cover by force. 2 Remove the sponge filter 3 Use a vacuum cleaner to remove dirt from the sponge filter carefully 4 Restore the sponge filter to the original position Place the sponge filter under the tabs 5 Restore the cover and fasten the screws at the four corners MEMO 0 If the sponge filter is damaged and requires replacement, or if dirt gets into the unit, consult your authorized dealer or nearby service center. 0 Sponge spacer Product no.: J3K-0134-00 83 Maintenance

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
Maintaining the Cabinet and Remote Control
0
Gently wipe off dirt on the cabinet with a soft cloth.
0
If it is extremely dirty, wet a cloth in water, wring dry and use it to wipe off the dirt, followed by wiping again with a dry
cloth.
0
Pay attention to the following as the cabinet may deteriorate in condition or the paint may come off.
0
Do not wipe with thinner or benzine
0
Do not allow prolonged contact with rubber or plastic products
0
Do not spray volatile chemicals such as insecticide
Cleaning and Replacing the Filter
Clean the filter every 2000 hours (more often in dusty conditions). Using a filter without cleaning may reduce the
brightness of the image. Dirt that enters the unit may also appear as shadows on the image.
1
2
3
4
Sponge filter (gray)
1
Loosen the screws at the four corners and remove the cover
0
The screws cannot be removed from the cover. Do not try to remove the screws from the cover by force.
2
Remove the sponge filter
3
Use a vacuum cleaner to remove dirt from the sponge filter carefully
4
Restore the sponge filter to the original position
Place the sponge filter under the tabs
5
Restore the cover and fasten the screws at the four corners
MEMO
0
If the sponge filter is damaged and requires replacement, or if dirt gets into the unit, consult your authorized dealer
or nearby service center.
0
Sponge spacer
Product no.: J3K-0134-00
83
Maintenance