JVC DX97US Instruction Manual - Page 28

28 EN MENUS FOR DETAILED ADJUSTMENT Recording Menus CAMERA The "m CAMERA" settings are effective when the Power Switch is set to both "A" and "M". However, the menu settings can be changed only when the Power Switch is set to "M". [ ] = Factory-preset REC MODE [SP]: To record in the SP (Standard Play) mode LP: Long Play-more economical, providing 1.5 times the recording time. NOTES: ● Audio Dubbing (੬ pg. 40) and Insert Editing (੬ pg. 40) are possible on tapes recorded in the SP mode. ● If the recording mode is switched, the playback picture will be blurred at the switching point. ● It is recommended that tapes recorded in the LP mode on this camcorder be played back on this camcorder. ● During playback of a tape recorded on another camcorder, blocks of noise may appear or there may be momentary pauses in the sound. SOUND MODE [12 BIT]: Enables video recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing. (Equivalent to the 32 kHz mode of previous models) 16 BIT: Enables video recording of stereo sound on two separate channels. (Equivalent to the 48 kHz mode of previous models) ZOOM 12X: When set to "12X" while using digital zoom, the zoom magnification will reset to 12X since digital zoom will be disengaged. [40X]*: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 12X (the optical zoom limit), to a maximum of 40X digital magnification. 700X*: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 12X (the optical zoom limit), to a maximum of 700X digital magnification. * Available only when the VIDEO/MEMORY Switch is set to "VIDEO". SNAP MODE [FULL]: Snapshot mode with no frame PIN-UP: Pin-Up mode FRAME: Snapshot mode with frame GAIN UP OFF: Allows you to shoot dark scenes with no picture brightness adjustment. [AGC]: The overall appearance may be grainy, but the image is bright. AUTO : The shutter speed is automatically adjusted. Shooting a subject in low or poor lighting at slow shutter speed provides a brighter image than in the AGC mode, but the subject's movements are not smooth or natural. The overall appearance may be grainy. While the shutter speed is being automatically adjusted, " " is displayed. NAVIGATION [MANUAL]: Enables thumbnail images to be made manually. (੬ pg. 36) 5SEC / 15SEC / 30SEC / 60SEC: The captured image is stored in the memory card as a thumbnail image when the recording time is over the navigation time. For example, "5SEC" is suitable to record short scenes with the thumbnail images. (੬ pg. 35) However, the stored thumbnail images may take up a lot of memory. In this case, using the memory card with large capacity is recommended. OFF: Disables the function. ● The " " indicator appears when "NAVIGATION" is set to other than "MANUAL" and "OFF". MANUAL The "q MANUAL" settings are effective only when the Power Switch is set to "M". [ ] = Factory-preset DIS OFF: Disables the function. [ON ]: To compensate for unstable images caused by camera-shake, particularly at high magnification. NOTES: ● Accurate stabilization may not be possible if hand shake is excessive, or depending on the shooting condition. ● The " " indicator blinks or goes out if the Stabilizer cannot be used. ● Switch off this mode when recording with the camcorder on a tripod. TELE MACRO [OFF]: Disables the function. ON: When the distance to the subject is less than 1 m (3.3 ft), set "TELE MACRO" to "ON". You can shoot a subject as large as possible at a distance of approx. 60 cm (2 ft). NOTE: Depending on the zoom position, the lens may go out of focus. [FULL] PIN-UP FRAME For details on the procedure, refer to "Snapshot (For Video Recording)" (੬ pg. 32).