JVC DX97US Instruction Manual - Page 43

Select Scenes RM-V717U (optional) FADE/WIPE EFFECT EDIT IN/OUT PLAY PAUSE R.A.EDIT ON/OFF CANCEL VCR REC STBY 6 Press PLAY (U) and then press R.A.EDIT ON/OFF on the remote control. ● The Random Assemble Editing Menu appears. Selected parameter 7 If using a Wipe/Fader at the beginning of the scene, press FADE/WIPE on the remote control. ● Cycle through the effects by pressing repeatedly, and stop when the one you want is IN OUT MODE 1-- -- : -- ~ 2 ~ 3 ~ 4 ~ 5 ~ 6 ~ 7 ~ 8 ~ T I ME CODE - - : - - TOTAL 00 : 00 displayed. 8 At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu. 9 At the end of the scene, press EDIT IN/OUT. The Edit- Out position appears in the Random Assemble Editing Menu. 10 If using a Wipe/Fader at the end of the scene, press FADE/WIPE. ● Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed. ● If you select a Wipe/Fader effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point. ● When you use Wipe/Fader effects, that time is included in the total time. 11 If using Playback Special Effects, press EFFECT. (੬ pg. 20) 12 Repeat steps 8 through 11 to register additional scenes. ● To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point. ● If you are not using Wipe/Fader or Program AE with special effects, repeat steps 8 and 9 only. EDITING EN 43 NOTES: ● When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them. ● If the search time for an in-point exceeds 5 minutes, the recording deck's Record-Standby mode will be cancelled and editing will not take place. ● If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version. ● Turning off the camcorder's power erases all registered Edit-In and Edit-Out points. ● If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Black & White Fader. In this case the Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use Black & White Fader during Random Assemble Editing. ● It is not possible to use Wipe/Fader effects and Program AE with special effects during Random Assemble Editing using a DV cable. ADVANCED FEATURES