JVC GR D90U Instructions - Page 6

HOW TO ATTACH THE CORE FILTER Attach the Core Filter(s) (if provided with your model ੬ pg. 5) to an optional cable(s). The Core Filter reduces interference. 1 2 3 cm 3 Stopper Release the stoppers on both ends of the Core Filter. Wind once Run the cable through the Core Filter, leaving approx. 3 cm of cable between the cable plug and the Core Filter. Wind the cable once around the outside of the Core Filter as shown in the illustration. • Wind the cable so that it is not slack. NOTE: Take care not to damage the cable. Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder. Close the Core Filter until it clicks shut. AUTOMATIC DEMONSTRATION Automatic Demonstration takes place when "DEMO MODE" is set to "ON" (factory-preset). % Ⅲ Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch y is set to " " or " " and no cassette is in the camcorder. Ⅲ Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minutes after that, the demonstration will resume. Ⅲ "DEMO MODE" remains "ON" even if the camcorder power is turned off. Ⅲ To cancel Automatic Demonstration: 1. Set the Power Switch y to " " while pressing down the Lock Button t located on the switch and press the MENU/VOLUME wheel % in. The Menu Screen appears. 2. Rotate the MENU/VOLUME wheel % to select " (SYSTEM)" and press it. 3. Rotate the MENU/VOLUME wheel % to select "DEMO MODE" and press it. The Sub Menu appears. 4. Rotate the MENU/VOLUME wheel % to select "OFF" and press it. 5. Rotate the MENU/VOLUME wheel % to select " RETURN", and press it twice. The normal screen appears. t y Sub Menu S Y S T EM DEMO MODE - OF F ON RETURN NOTE: If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder. EN 6 None