JVC GRDF430U Instructions - Page 13

GETTING STARTED How To Attach The Core Filter Attach the core filters to the cables. The core filter reduces interference. 1 Release the stoppers on both ends of the core filter. Stopper 2 Run the cable through the core filter, leaving approx. 3 cm (1-3/16") of cable between the cable plug and the core filter. Wind the cable once around the outside of the core filter as shown in the illustration. Core filter 3 cm (1-3/16") GETTING STARTED EN 13 Power This camcorder's 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment. Charging The Battery Pack BATT. RELEASE Battery pack Open the cover. To DC connector Arrow Battery pack mount mark Wind once. 3 Close the core filter until it clicks shut. Power switch POWER/CHARGE lamp NOTES: ● Take care not to damage the cable. ● When connecting a cable, attach the end with the core filter to the camcorder. AC Adapter To AC outlet 1 Set the Power Switch to "OFF". 2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a. 3 Slide the battery pack to the right until it locks in place b. 4 Connect the AC Adapter to the camcorder. 5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started. 6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder. CONTINUED ON NEXT PAGE