JVC KD-X250BT Instruction Manual - Page 13

Bluetoothா connection Connecting/Disconnecting a registered device manually To connect 1 (Hold) 2 Select . - -/ - 3 Select the desired device. "CONNECTING"#"[Device Name]" scrolls on the display when the unit is connecting to the device. "CONNECTED"#"[Device Name]" scrolls on the display when the device is connected. 4 Press MENU to exit. To disconnect 1 (Hold) 2 Select . - -/ - 3 Select the desired device. "DISCONNECT"#"[Device Name]" scrolls on the display when the device is disconnected. 4 Press MENU to exit. Deleting a registered device 1 (Hold) 2 Select . - - - [Device name] - "DELETED" appears when the device is deleted. 3 Press MENU to exit. Bluetooth compatibility check mode You can check the connectivity of the supported profile between the Bluetooth device and the unit. 1 Enter check mode. (Hold) (Hold about 3 seconds) "BLUETOOTH")"CHECK MODE" appears. "SEARCH NOW USING PHONE"#"PIN IS 0000" scrolls on the display. 2 Search and select "JVC UNIT" on the Bluetooth device within 3 minutes. 3 Perform pairing (A), (B) or (C) depending on what appears on the display. (A) "PAIRING"#"XXXXXX" (6-digit passkey): Ensure that the same passkey appears on the unit and Bluetooth device, then operate the Bluetooth device to confirm the passkey. (B) "PAIRING"#"PIN IS 0000": Enter "0000" on the Bluetooth device. (C) "PAIRING": Operate the Bluetooth device to confirm pairing. After pairing is successful, "PAIRING OK"# "[Device Name]" appears and Bluetooth compatibility check starts. If "CONNECT NOW USING PHONE" appears, operate the Bluetooth device to allow phonebook access to continue. The connectivity result flashes on the display.  "H.FREE OK" *1 and/or "A. STREAM OK" *2 # "[Device Name]": Compatible  "CONNCT FAIL")"TRY CONNECT": Not compatible *1 : Compatible with Hands-Free Profile (HFP) *2 : Compatible with Advanced Audio Distribution Profile (A2DP) After 30 seconds, "PAIRING DELETED" appears to indicate that pairing has been deleted, and the unit exits check mode.  To cancel check mode, turn off the unit by pressing and holding SOURCE.  Delete the pairing on the Bluetooth device before pairing with this unit. (' page 12) ENGLISH‫ |ޓ‬13