JVC KD-X250BT Instruction Manual - Page 2

IC (Industry Canada) Notice This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The term "IC:" before the certification/ registration number only signifies that the Industry Canada technical specification were met. 0 Contains Bluetooth Module FCC ID: XQN-BTR60X 0 Contains Bluetooth Module IC: 9688A-BTR601  Caution This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person's body (excluding extremities: hands, wrists, feet and ankles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. . .  Warning Do not operate any function that takes your attention away from safe driving.  Caution Volume setting:  Adjust the volume so that you can hear sounds outside the car to prevent accident.  Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the output level. General:  Avoid using the USB device or iPod/iPhone if it might hinder driving safety.  Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.  Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit. 2 |‫ޓ‬ENGLISH