JVC MX-KA3 Instruction Manual - Page 16

Using the CD Player Programming the Playing Order of the Tracks You can program the playing order of the tracks on all the CDs. Note that you can only make a program when the CD Player is stopped. ❏ You can program up to 32 tracks in any desired order including the same tracks. To Make a Program 1 Load CDs 2 In Stop mode, set the CD Player in Program Play mode. On the Unit Press the PROGRAM button to light the "PRGM" indicator on the display. At the same time, "PROGRAM" appears on the display. On the Remote Control Press the PROGRAM/RANDOM button until "PROGRAM" appears on the display. The "PRGM" indicator also lights up on the display. Each time you press the button, the display changes as follows: PROGRAM = RANDOM = Blank display (Normal Play) = (back to the beginning) • If a program is already made, the last step of the program will be displayed. 3 Press one of the Disc button (CD1-CD3) to select the CD you want to program. The display will change to the Program Entry display. CD 1 or CD1 Disc number Track number 4 Select the track you want to program. Using the Unit While the display is blinking, press the 4 or ¢ button to select the track, then press the SET button within 5 seconds. The program order number will be assigned from P-1. or PRESET Disc number Track number SET Program order number Using the Remote Control Press the numeric keys to directly enter the track number. Then, the program order number will be assigned from P-1. • To delete the current program step, press the CANCEL button on the Unit. 5 Repeat steps 3 and 4 to program other tracks on the same CD or the other CD. 6 To play the program, Press the CD 6 but- ton. For details, see "To Play the Program You Have Made" mentioned below. To confirm the programmed contents, while the CD player is stopped, press the 4 or ¢ button on the Remote Control. To delete all the tracks in the program, while the CD Player is stopped, press the 7 button. To Modify the Program, while the CD Player is stopped, press the CANCEL button, the last track in the program is deleted. To add new tracks to the end of the program, repeat above steps 3 and 4. • If you try to program a track number that does not exists on the CD, your entry will be ignored. • If you try to program the 33rd track, "FULL" appears on the display. To Play the Program You Have Made Press the CD 6 button. The System plays the tracks in the order you have programmed them. • To use Repeat Play for Program Play, press the REPEAT but- ton to select "ALL" or "1" before starting playback. For details, see "Repeating Tracks" on page 15. ❏ You can skip to a particular program track by pressing the 4 or ¢ button during Program Play. ❏ To stop playing, press the 7 button once. If you press the 7 button, while the CD Player is stopped, the program is deleted. To Exit and Re-enter Program Play The program you have made is stored in memory. So, you can exit Program Play temporarily or re-enter Program Play unless you delete the program. To exit the program mode once, while the CD Player is stopped, press the PROGRAM button on the Unit or the PROGRAM/RANDOM button on the Remote Control to light off the "PRGM" indicator. By changing the source to the other (e.g. Tuner), the CD Player also exits Program Play mode. To re-enter Program Play mode, press the PROGRAM or PROGRAM/RANDOM button until the "PRGM" indicator lights up again. • Even when the power is turned off (standby mode), the programmed tracks are not deleted. So, you can re-enter Program Play mode. 14