JVC RX-778VBK Instruction Manual - Page 20

English To tune in a preset station On the front panel: 1. Turn SOURCE SELECTOR to select the band (FM or AM). The last received station of the selected band is tuned in. 2. Press TUNER PRESET. SOURCE SELECTOR TUNER PRESET 3. Turn MULTI JOG until you find the channel you want. MULTI JOG • Turning it clockwise increases the channel numbers. • Turning it counterclockwise decreases the channel numbers. From the remote control: 1. Press FM/AM. • Each time you press the button, the band alternates between FM and AM. FM/AM CNTR 2. Press the 10 keys to select a preset 1 2 3 channel number. TEST MENU REAR•L • For channel number 5, press 5. 4 EFFECT • For channel number 15, press +10 then 5. 7/P 5 6 ENTER REAR•R 8 9 • For channel number 20, press +10 then 10.SEA MODE SUBWOOFER • For channel number 30, press +10, +10, 10 0 +10 then 10. RETURN FM MODE/MUTING 100+ Note: When you use the 10 keys on the remote control, be sure that they are activated for the tuner, not for the CD and others. (See page 41.) Selecting the FM Reception Mode When an FM stereo broadcast is hard to receive or noisy You can change the FM reception mode while receiving an FM broadcast. • You can store the FM reception mode for each preset station. Press FM MODE on the front panel or FM MODE/MUTING on the remote control. • Each time you press the button, the FM reception mode alternates between "AUTO" and "MONO." FM MODE SUBWOOFER 0 FM MODE/MUTING On the front panel On the remote AUTO: When a program is broadcasted in stereo, you will hear stereo sound; when in monaural, you will hear monaural sounds. This mode is also useful to suppress static noise between stations. The MUTE AUTO indicator lights up on the display. MONO: Reception will be improved although you will lose the stereo effect. In this mode, you will hear noise while tuning into the stations. The MUTE AUTO indicator goes off on the display. 18 Note: When using the FM MODE/MUTING button on the remote control, be sure that the 10 keys are activated for tuner, not for the CD and others. (See page 41.) Assigning Names to Preset Stations You can assign a name of up to four characters to each preset station. When a preset station is tuned in, its assigned name will appear on the display. Before you start, remember... • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. • You can use the following characters: Space, A - Z, and 0 - 9. On the front panel ONLY: 1. Tune in a preset station. See the left. 2. Press TUNER/SEA MEMORY. TUNER/SEA MEMORY The preset channel number starts flashing for about 10 seconds. CH- VOLUME • If you turn MULTI JOG while the preset channel number is flashing, you can change the preset channel number. 3. Press TUNER PRESET, while the preset channel number is flashing. The first character position starts flashing. TUNER PRESET CH- 4. Turn MULTI JOG to select the first character, while the first character position is flashing. VOLUME MULTI JOG CH- 5. Press TUNER PRESET, while a character you want is flashing. The next character position starts flashing. TUNER PRESET CH- VOLUME 6. Repeat steps 4 and 5 to enter up to four characters. 7. Press TUNER/SEA MEMORY while the last selected character is flashing after you have assigned a name. TUNER/SEA MEMORY To erase the input characters Insert spaces using the same procedure described above.