JVC RX-778VBK Instruction Manual - Page 27

English Notes: • You can adjust the speaker output levels without outputting the test tone. • No test tone comes out of the center speaker when "CENTER SPK" is set to "NONE" (see page 14). • No test tone comes out of the rear speakers when "REAR SPK" is set to "NONE" (see page 14). • If the TV is turned on and the proper video input is selected on the TV, the test tone screen will appear on the TV. • The signal indicators also light on the display while the test tone comes out of the speakers. L: Lights when the test tone comes out of L CR the left front speaker. C: Lights when the test tone comes out of LS RS the center speaker. R: Lights when the test tone comes out of the right front speaker. RS: Lights when the test tone comes out of the right rear speaker. LS: Lights when the test tone comes out of the left rear speaker. 4. Adjust the speaker output levels. • To adjust the center speaker level, press CNTR -/+ (from -10 dB to +10 dB). • To adjust the left rear speaker level, press REAR•L -/+ (from -10 dB to +10 dB). CNTR 2 3 MENU REAR•L 5 6 ENTER • To adjust the right rear speaker level, press REAR•R -/+ (from -10 dB to +10 dB). REAR•R 8 9 5. Press TEST again to stop the test tone. TEST 4 On the front panel: You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back. 2. Adjust the speaker output levels. 1) Press BALANCE/SURROUND ADJUST repeatedly until one of the BALANCE/SURROUND ADJUST indications appears on the display. "CENTER LEVEL": To adjust the center speaker level. "REAR L LEVEL": To adjust the left rear speaker level. "REAR R LEVEL": To adjust the right rear speaker level. MULTI JOG 2) Turn MULTI JOG to adjust the selected speaker output level (from -10 dB to +10 dB). 3) Repeat 1) and 2) to adjust the other speaker output levels. JVC Theater Surround adjustments Before you start, remember... • Make sure that you have set the speaker information correctly (see page 14). • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. • You cannot adjust the rear speaker output levels when you have set "REAR SPK" to "NONE." See page 14. • You cannot adjust the center speaker output level when you have set "CENTER SPK" to "NONE." See page 14. From the remote control: 1. Press SURROUND MODE repeatedly until "THEATER" or SURROUND MODE "DIG THEATER" appears on the display. • When "THEATER" is selected, the PRO LOGIC, DSP, and THEATER indicators also light up on the display. • When "DIG THEATER" is selected, the DSP, THEATER and Ÿ DIGITAL indicators also light up on the display. 2. Press SOUND. SOUND The 10 keys are activated for sound adjustments. 1. Press DOLBY SURROUND to DOLBY SURROUND activate an appropriate Surround mode - PRO LOGIC or DOLBY DIGITAL. • Each time you press the button, the Surround mode turns on and off alternately. • When "PRO LOGIC" is selected, the PRO LOGIC indicator lights up on the display. 25