JVC RX-D212B Instructions - Page 12
Connecting the power cord
UPC - 046838026058
View all JVC RX-D212B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English About video signal conversion This receiver can convert video signals. See the table below about video signal conversion. Video Input Converted Video Output Component Component S-video S-video Video (composite) Video (composite) To convert composite video and S-video signal into component video signal, set the "DVD VIDEO IN," "VCR VIDEO IN," or "DBS VIDEO IN" to "" (see page 25). • If using composite video cable for connecting to the video input and using S-video cable for connecting to the video output, the video signal is converted into S-video signal automatically. The signal is emitted through the S-video output jacks of MONITOR OUT, VCR OUT (REC), and DVR OUT (REC). • Pictures may be distorted if the signals are converted. If this happens, connect the playback source component and TV using the cords of the same type. • Incoming signal of component can be emitted only through the component output jacks. Digital connection This receiver is equipped with three DIGITAL IN terminals-one digital coaxial terminal and two digital optical terminals. To reproduce the digital sound, use the digital connection in addition to the analog connection methods described on pages 7 to 9. Digital coaxial cable (not supplied) Digital optical cable (not supplied) Turn off all components before making connections. • When you connect other components, refer also to their manuals. NOTES • When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components: - 1(DVR/DVD): For DVD recorder or DVD player - 2(DBS): For DBS tuner - 3(VCR): For VCR If you connect other components, change the digital input (DIGITAL IN) terminal setting correctly. See "Setting the digital input (DIGITAL IN) terminals-DIGITAL IN 1/2/3" on page 25. • Select the correct digital input mode. See "Selecting the analog or digital input mode" on page 12. • When you want to operate the connected component (except DBS tuner) using the AV COMPU LINK remote control system (see pages 35 and 36), connect them also as described on pages 7 to 9. Connecting the power cord When all the audio/video connections have been made, connect the AC power plug to the wall outlet. Make sure that the plugs are inserted firmly. The standby lamp lights in red. CAUTIONS: • Do not touch the power cord with wet hands. • Do not alter, twist or pull the power cord, or put anything heavy on it, which may cause fire, electric shock, or other accidents. • If the cord is damaged, consult a dealer and have the power cord replaced with a new one. NOTES • Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference. • The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases: - When you unplug the power cord. - When a power failure occurs. • When you unplug the power cord with the receiver on and connect the power cord again, the receiver enters standby mode. When the component has a digital coaxial output terminal, connect it to the 1(DVR/DVD) terminal, using a digital coaxial cable (not supplied). DIGITAL IN 1(DVR/DVD) 2(DBS) 3(VCR) When the component has a digital optical output terminal, connect it to the 2(DBS) or 3(VCR) terminal, using a digital optical cable (not supplied). Before connecting a digital optical cable, unplug the protective plug. 10