JVC RX-D212B Instructions - Page 21

English 4 Press MEMORY again while the selected preset number is flashing on the display. 5 Repeat steps 1 to 4 until you store all the desired channels. Changing the channel information While listening to XM Satellite Radio, the currently selected channel information appears on the display. You can change the kind of channel information. To erase a stored preset channel Storing a new channel on a used preset number erases the previously stored one. From the remote control ONLY: Press DISPLAY. Each time you press the button, the channel information changes as follows: To tune in a preset channel From the remote control: 1 Press XM. The last received channel is tuned in. 2 Press the numeric buttons (0 - 9, h10) to select a preset channel number. • For preset number 5, press 5. • For preset number 10, press h10, 1, then 0. • For preset number 15, press h10, 1, then 5. On the front panel: Before you start, remember... There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again. 1 Turn SOURCE SELECTOR to select "XM." The last received channel is tuned in. 2 Press TUNER PRESET. "P" flashes on the display, and MULTI JOG now works for selecting preset channels. 3 Turn MULTI JOG to select a preset number. • To increase the preset numbers, turn MULTI JOG clockwise. • To decrease the preset numbers, turn MULTI JOG counterclockwise. CHAN (channel name)* = NAME (artist name/feature) = TITLE (song/program title) = CAT (category name) = Back to the beginning * "CHAN" is the initial setting. EX.: When the category name is selected: DIGITAL AUTO L R LINEAR PCM S.WFR DIGITAL AUTO L R LINEAR PCM S.WFR After one second NOTES • If you turn off the power or select another source, the display is changed back to the initial setting. • When you tune in to another channel, the channel name appears on the display and then the channel information you have selected appears. • When all the text information cannot be shown on the display at the same time, the text scrolls. • Some characters cannot be displayed correctly. Messages on the display When problems occur, a message appears on the display. In this case, refer to the following solution. Message NO SIGNAL CHECK ANTENNA LOADING OFF AIR UPDATING • Channel number and Preset number, channel number, and Channel number and "CH---" • Preset number and "--->CH---" Possible cause Signals are too weak. The XM Mini-Tuner Home Dock antenna is not connected properly. This receiver is loading the channel information and audio data. Selected channel is not currently broadcasting any signal. The latest encryption code is being updated. No text information for the selected channel is available. Selected channel does not exist or is not subscribed yet. Solution Move the XM Mini-Tuner Home Dock antenna near a south-facing window or where "Channel 1" can be heard clearly. Check the connection (see page 5). It takes a few minutes to complete. Wait until loading is finished. Select another channel. Wait until updating is finished. 19