JVC RXD702B Instructions - Page 10
Connecting the speakers
UPC - 046838019142
View all JVC RXD702B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English Connecting the speakers Do not connect the AC power plug to the wall outlet until all connections are completed. Speaker Layout Diagram SW FL C FR SL SR SBL (*SB) SBR Right surround back speaker (SBR) Center speaker (C) CAUTION:SPEAKER IMPEDANCE 6 -16 SUBWOOFER OUT *Left surround back speaker (SBL) RIGHT LEFT SURROUND BACK SPEAKERS RIGHT LEFT SURROUND SPEAKERS CENTER SPEAKER RIGHT LEFT FRONT SPEAKERS Right surround speaker (SR) Left surround Right front speaker (SL) speaker (FR) Powered subwoofer (SW) Left front speaker (FL) CAUTIONS: • Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (6 Ω - 16 Ω). • DO NOT connect more than one speaker to one speaker terminal. Connecting the speakers Turn off all components before making connections. 1 2 3 4 1 Twist and remove the insulation at the end of each speaker cord. 2 Turn the knob counterclockwise. *When using a single speaker for the surround back speaker You can enjoy the surround sound by one surround back speaker. When using one surround back speaker, - set "S BACK OUT" to "S BACK OUT: 1SPK" (see page 29) and - connect the surround back speaker to the left surround back speaker terminal. (No sound comes from the speaker if you connect it to the right surround back speaker terminal.) Connecting the powered subwoofer By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in digital software. Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cord with RCA pin plugs (not supplied). • Refer also to the manual supplied with your subwoofer. After connecting all the speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 23, 24, 28, and 29. NOTE You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you. 3 Insert the speaker cord. • For each speaker, connect the (+) and (-) terminals on the rear panel to the (+) and (-) terminals marked on the speakers. 4 Turn the knob clockwise. 8