Jenn-Air JGD8130ADS Installation Instruction - Page 5
Appliance Pressure Regulator Conversion, Conversion To LP Gas, Control Settings, Minimum Spacing - installation guide
View all Jenn-Air JGD8130ADS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Appliance Pressure Regulator Conversion (See Illustration "D") This unit is supplied with a Maxitrol Appliance Pressure Regulator. Follow the instructions in illustration "D". MAXITROL APPLIANCE PRESSURE REGULATOR APPLY DOWNWARD FINGER PRESSURE LP AT DISC EDGES TO REPLACE PIN IN CAP NAT CONVERTER CAP AND PIN NAT APPLY SIDEWARD FINGER PRESSURE TO LP REMOVE PIN FROM CAP ILLUSTRATION "D" Conversion To LP Gas This appliance is shipped from the factory equipped for use with Natural Gas. To convert it from Natural Gas for use with LP Gas, perform steps 1 through 4. 1. Remove natural gas orifice hoods. Install color coded orifice hoods supplied, located in a pack attached to the outer plenum area of this appliance. (See Illustration "E", and LP Gas Conversion Instructions on page 6). 2. Invert cap in convertible appliance pressure regulator (if so equipped) located at entrance to gas manifold. 3. Adjust air shutters on individual burners for proper flame appearance. 4. Adjust low flame setting at each burner by turning adjustment screw in center of valve stem. To make these conversion adjustments follow the instructions and illustrations ("A" through "E" on pages 4 - 5). This appliance is shipped from the factory with orifice hoods drilled for use with Natural Gas. To convert from Natural Gas to LP, apply a 1/2² open-end wrench to hex section of orifice hood. TURN COUNTERCLOCKWISE TO REMOVE. Save the Natural Gas orifice hoods just removed from this appliance for future use. Install color coded orifice hoods supplied. (See LP Gas Conversion Instructions above and page 6). TURN CLOCKWISE TO INSTALL. Hold dimension specified in Illustration "E". 1/2² OPEN END WRENCH ILLUSTRATION "E" TURN COUNTERCLOCKWISE TO REMOVE 11/16² TURN CLOCKWISE TO TIGHTEN ORIFICE HOOD Control Settings The size and type of cookware and the amount and type of food being cooked will influence the setting needed for best cooking results. The setting indicated should serve as a guide while you become familiar with your cooktop. Use the HI flame setting to quickly bring foods to a boil or to begin a cooking operation. Then reduce to a lower setting to continue cooking. Never leave food unattended over a HI flame setting. Med setting is used to continue a cooking operation. Food will not cook any faster when a HI flame setting is used than that is needed to maintain a gentle boil. Remember, water boils at the same temperature whether boiling gently or vigorously. Use Lo setting to keep food at serving temperatures without further cooking. You may find that some cooking may take place if the cookware is covered. Minimum Spacing Requirement Convertible Gas Cooktops For installing a Double Bay Downdraft Cooktop in combination with another Downdraft Cooktop, the minimum spacing between adjacent units must be provided, as shown, for satisfactory performance. 5