Jenn-Air JUCFP242HL Owners Manual 1 - Page 11
Move The Refrigerator Drawers To, Final Location, Install Custom Overlay Panel
View all Jenn-Air JUCFP242HL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
4. The ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the 1/4" (6 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. 5. Plug in refrigerator drawers or reconnect power. MOVE THE REFRIGERATOR DRAWERS TO FINAL LOCATION 1. Place top of cardboard carton or plywood under the appliance. Remove dolly. 2. Do not remove film or cover. WARNING ATTACH THE OVERLAY PANEL NOTE: If the overlay hooks are not installed, see "Custom Overlay Drawer Panels" for overlay hook locations. The location of the hooks must be as precise as possible. If the custom panel is incorrectly placed, the panel may interfere with optimal use of the drawers. 1. Attach the custom handle of your preference on the overlay before attaching the overlay to the drawer of the refrigerator. NOTE: Custom handles may vary in dimensions. Holes must be made on the panel according to the specific dimensions of your handle. 2. Attach the hooks to their corresponding recessions on the panel, using the SS Flat M4x12 screws. Two screws are needed per hook. The hooks must be on the outer edge of the panel. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 3. Plug into a grounded 3 prong outlet. 4. Move the refrigerator drawers straight back and evenly in front of the opening. INSTALL CUSTOM OVERLAY PANEL IMPORTANT: For standard stainless steel models, skip these instructions and go to "LEVEL THE REFRIGERATOR DRAWERS" section. Create a custom overlay panel according to the specifications in "Custom Overlay Drawer Panels." JennAir is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator drawers for service. 3. Gently pull back the gasket from the top corners of the door until you can see the screw that is behind the gasket. There is one screw on each side. It is not necessary to remove the gasket. 4. Remove the screws behind the gasket (one per side). 5. Align the panel to the drawer and position the overlay panel 1/2" (12.5 mm) higher than the door. Position the overlay hooks with the pilot holes and push the hooks into the holes. The drawer has insulant foam in its interior so you may feel some interference while pushing. Push until the hooks go through the foam. 11