Jenn-Air JUCFP242HL Owners Manual 1 - Page 12

6. Push straight down on the overlay panel to secure the overlay hooks to the drawer. 7. Using the self-tap wood screws (two per drawer; one in each corner of the drawers), attach the panel to the drawer. NOTE: Do not put the screws removed in step 4 back on the door. 8. Once the overlay is securely attached to the drawer with the two screws, put the gasket back in its place by pressing it against the door until the gasket is even and firmly secured. 3. Remove the level and close the top drawer. Check the gap between the top of the drawer and the countertop. If the gap measures less than 3/8" (9.5 mm) minimum, turn all four leveling bolts equally to the left to raise the leveling legs (this will lower the appliance). Recheck the level. 4. Open both drawers less than midway. Place the level on the side flange beside the drawers as shown. Turn the front leveling bolts together in order to either raise or lower the appliance until the sides of the refrigerator drawers are plumb. LEVEL THE REFRIGERATOR DRAWERS IMPORTANT:  Overlay Model-Be sure to install the custom overlay drawer panels before leveling the refrigerator drawers. See "Install Custom Overlay Panel."  Before installing the refrigerator drawers, be sure that the countertop is level.  If the countertop is not level, adjust the refrigerator drawers' leveling legs until the appliance is square with the countertop. Be sure to maintain 3/8" (9.5 mm) minimum gap between the top of the drawer and the countertop. 1. Open the top drawer and place the level across the top drawer as shown. Check the level from left to right. A A A. Check the level from front to back. 5. Remove the level and close the drawers. Recheck the gap between the top of the drawer and the countertop. If the gap measures less than 3/8" (9.5 mm), turn all four leveling bolts equally to raise the leveling legs (this will lower the appliance). Recheck the level. NOTE: Be sure to recheck the horizontal level of the top drawer. 6. Be sure all four levelers are on the floor and supporting the full weight of the refrigerator drawers. A. Check the level from left to right. 2. Turn the leveling legs (front and back) until the top drawer measures level from left to right. COMPLETE INSTALLATION 1. Remove all boxes, parts packages and packing materials from the interior of the refrigerator drawers. 2. Remove the film. 3. Clean the refrigerator drawers before use. Refer "CARE AND CLEANING" section. 4. The controls are preset at the factory to the recommended settings. Be sure that the compressor is operating properly and that all the lights are working. 5. If construction will continue after the refrigerator drawers have been installed, turn OFF the power for both drawers. To get the most efficient use from your new refrigerator drawers, read the "Refrigerator Drawers Use" section. 12