Jensen JGC9536ADB Installation Manual
Jensen JGC9536ADB - 36" Gas Cooktop Manual
 |
UPC - 719881123813
View all Jensen JGC9536ADB manuals
Add to My Manuals
Save this manual to your list of manuals |
Jensen JGC9536ADB manual content summary:
- Jensen JGC9536ADB | Installation Manual - Page 1
CONVERTIBLE GAS GRILL COOKTOP SERIES JGD8130 & JGD8345 JENN-AIR DIMENSIONS SHOWN IN BOTH INCHES AND CENTIMETERS *Blower may be rotated for horizontal or verticaldirection by looseningnuts aroundblower inlet. Accessible insideventilation chamber. • NOTICE TO INSTALLER: Leave these instructions with - Jensen JGC9536ADB | Installation Manual - Page 2
Cabinetry Over Your Jenn-Air Grill *A = 30" (76.2 cm) minimum verticat clearance between cooking surface and construction above the appliance. *B = 13" (33.02 cm) maximum depth of cabinets installed above cooking top. Do_edl_nes tnd_a_ _nge hood construction i * ÷B*_. of local codes, with - Jensen JGC9536ADB | Installation Manual - Page 3
Installer counter top laminate. 4. Countertop must be supported within 3" of cutout. Minimum horizontal clearance cookingsurface to 18" (45,7 cm) above the cooking surface is: 15116"(2.38 cm) at rear the factory with air shutters adjusted for use with N=ural Gas. If further adjustment is necessary, or - Jensen JGC9536ADB | Installation Manual - Page 4
factory with low and mediumflame settingsadjusted for use with Natural Gas. If further adjustment is necessary, or to readjust for use with LP, proceed as follows: 1. Light burner and set control knob for low flame. 2. Remove control knob from valve stem. , CAUTION _EVER_USE A METAL BLADE TO PRY - Jensen JGC9536ADB | Installation Manual - Page 5
at serving temperatures without further cooking. You may find that some cooking may take place if the cookware is covered. I Minimum Spacing Requirement Convertible Gas Cooktops For installing a Double Bay Downdraft Cooktop in combination with another Downdraft Cooktop, the minimum spacing - Jensen JGC9536ADB | Installation Manual - Page 6
Natural Gas To Propane Gas (LP) Conversion Instructions ...,, . __ Authorized Service Contractor Gas pressure required - 10" W.C. Incoming Propane Gas pressure required to appliance pressure regulator- 11" - 12" W,C. Propane Gas conversion orifice hoods are supplied with these models• Propane Gas - Jensen JGC9536ADB | Installation Manual - Page 7
NATURALGAS Propane Gas (LP) To Natural Gas Conversion Instructions If this appliance has been converted for use with LP Gas, each of the following modifications must be performed to convert the unit back to Natural Gas '_NatuGr_ascOnversisltoonbeperformebdya, 3e_.ir /Authorized Service Contractor - Jensen JGC9536ADB | Installation Manual - Page 8
pmoaokre dsuucrtiengit cporancfoticrmess. tc Contact your installer if the ventilation system will not remove smoke or cooking fumes from well trimmed cuts of meat. If ventilation problems persist contact your authorized Jenn-Air Service Contractor. ZJENN-AIR 4_ WEST FOURTH STREET, NORTH • NEWTON
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
CONVERTIBLE GAS GRILL
COOKTOP SERIES
JGD8130 & JGD8345
JENN-AIR
DIMENSIONS SHOWN IN BOTH INCHES AND CENTIMETERS
*Blower
may be rotated for horizontal or
vertical
direction by
loosening
nuts
aroundblower
inlet. Accessible
inside
ventilation
chamber.
•
NOTICE
TO INSTALLER:
Leave these instructions with the appliance.
•
NOTICE TO CONSUMER:
Retain these instructions for future reference.
REGULATOR
TIE DOWNBOLT
ON EACHEND
BOX
COVER
GREASE
BLOWERCAN
BE
CONTAINER
SWIVELED90
°
29"
_1/
21"+1116"
7
Q/16"
Min.
Cbarar_e
2.38cm
SELECTAPPROPRIATE
DUCTCUTOUT(SEE
DUCTING
INSTALLA-
TION
INSTRUCTIONS).
_EAS[
CONTA
t
NER
2
7/8
°_
_13
3/4"--,.*_.|t
13/115-_..
7.3
Cm
34.9
cm
30.0
cm
TtE
DOWNBOLT
ONEACHEND
GREASE
BLOWERCAN
BE
CONTAINER
SWIVELED90
'=
APPUANCEPRF.SSURE
REGULATOR
SELECTAPPROPRIATE
DUCTCUTOUT
DUCTINGINSTALLA-
TION
INSTRUCTIONS).
43
114" +lt
21"
_-
1/16"
79/16"
19.21cm
1 7_"
Min.
4.76cm
COH_AI_
INSTRUCTIONS TO INSTALLER
•
Dimension "A"- Provide 2"
rain.
(5.08 cm) cabinet clearance
to
motor
for
coolingpurpose,
•
Note
-
Where possible, 6"
(15.24
cm) is recommended
for
motor/blowerservice.
•
Side Clearance -
Grills
installednear a side wall must allow a
minimum
clearance of 8".
•
Access must
be providedto
remove
and empty grease container(s),
8101P406-60
(o9-ol-oO)
/