Jensen JGC9536ADB Installation Manual - Page 2

Installing Cabinetry Over Your Jenn-Air Grill *A = 30" (76.2 cm) minimum verticat clearance between cooking surface and construction above the appliance. *B = 13" (33.02 cm) maximum depth of cabinets installed above cooking top. Do_edl_nes tnd_a_ _nge hood construction i * ÷B*_. of local codes, with the latest edition of the National Electrical Code ANSI/NFPA No. 70 USA or current CSA STANDARD C22.1 Canadian Electrical Code part 1. Warranty Isvoid on JEN_AIR equ_rne_ _ _'_l tt-_ asr_x_nmen_.bymar_fa_. _,] walt ,caps and tr__ _,ns must be _Uzed fot--_ J f operationand installation. 1 * To eliminate associated potential hazards such as reaching over open flames, avoid use of cabinets above cooktop for storage space. Cabinet Bottom Figure 2 Cabinets Above Cooking Top Maximum depth of cabinets installed above cooking top is 13 inches. CAUTION: SOME CABINETS AND BUILDING MATERIALS ARE NOT DESIGNED TO WITHSTAND THE HEAT PRODUCED BY THE NORMAL SAFE OPERATION OF A LISTED APPLIANCE. DISCOLORATION OR DAMAGE, SUCH AS DELAMINATION, MAY OCCUR. Installation Of Appliance Follow accompanying ducting instructions carefully. This appliance is designed to always be vented outdoors, The Countertop Cutout, Cabinet Front Cutout and Duct Opening should be prepared according to the illustration on pages 1 and 2. The installation of this appliance must conform with local codes or, in the absence of local codes, with the latest edition of the National Fuel Gas Code, ANSI Z223.1 USA or current CAN/CGA-B149 INSTALLATION CODE. The electricalsupply required is 110/120 Volt, A.C., 15 amp, 60 Hz. This appliance is equipped with a grounded tpe power cord. A grounded outlet must be provided, it is recommended, for convenience, this outlet be located in the area shown in the shaded illustration (see figure 2). This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence ConnectingApplianceTo Gas Supply A TRAINED SERVICEMAN OR GAS APPUANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION. Leak teating of the appliance shall f_e oonducted by the installer aoeording to rite instructions given. install a manual shutoffvalve in an accessible location inthe gas line external to this appliance for the purpose of turning on or shutting off gas to the appliance. Make the gas connection to the inlet to the appliance pressure regulator on this appliance with a 112" male pipe thread. Use an approved pipe joint compound resistant to the action of LP gas at pipe connections. Test all joints for gas leaks with a soap and water solution or other accepted leak detection means. Never test for gas leaks with an open flame.