Jensen MPX6411 Instruction Manual - Page 20
Troubleshooting, Specifications - harness
UPC - 043258302700
View all Jensen MPX6411 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
TROUBLESHOOTING Problem Does not operate (display does not light) No power to unit No speakers operate (display lights normally) Not all speakers operate Blows fuses CD skips too much Cause Corrective Action No power to yellow wire; Check connection with test light; no power to red wire check vehicle fuse with test light. Inline fuse blown Replace fuse. Inline fuse blown Check/replace fuse. Speaker harness not con- Connect speaker harness; check nected speaker wires. Incorrect splices or con- Check all splices and connec- nections tions. Speaker wires shorting to Check splices, insulate all bare chassis ground or to each wires. other Power wire shorting to ground Make sure wire is not pinched. Speaker wires shorting to Make sure wire is not pinched. ground Incorrect fuse/fuse too small Install fuse of correct rating. Receiver mount is not Check mounting and backstrap, solid or backstrap is not tighten if needed. secure SPECIFICATIONS MPX6411 CEA Power Ratings Power Output 16 watts RMS X 4 channels into 4-ohms @ < 1% THD+N Signal to Noise Ratio 90dBA below reference. (Reference: 1 watt, 4-ohms) Dynamic Power 76 Watts @ 4-Ohms all channels driven Frequency Response . . . . . 20Hz to 20kHz (-3dB), Auxiliary input used as source reference Reference Supply Voltage 14.4VDC CD Player Signal to Noise Ratio 90dBA Frequency Response 20Hz to 20kHz, -3dB Channel Separation 55dB @ 1kHz D/A converter 1-Bit/Ch FM Tuner Tuning Range 87.5MHz - 107.9MHz Mono Sensitivity 12dBf 50dB Stereo Quieting Sensitivity 16dBf Stereo Separation @ 1kHz 30dB Frequency Response 30Hz to 14kHz, -3dB AM Tuner Tuning Range 530kHz - 1720kHz Sensitivity @ 20dB Signal to Noise 30uV Frequency Response 50Hz - 2kHz, -3dB Auxiliary Input Input Sensitivity 400mV RMS for 1 watt RMS into 4-ohms Frequency Response 20Hz to 20kHz, -3dB Input Impedance 10k-ohms General Power Supply 11 to 16VDC, negative ground Fuse 15 amp, ATO type Wire Harness 20-pin quick-disconnect DIN chassis dimensions 2" X 7" X 7" (51mm x 178mm x 178mm) Specifications subject to change without notice. 16